![]() ![]() In this case eCUT will create file c:\eCut\temp\t Here You can select plotter from list of installed on Your PC.Īnd also not allow eCUT print directly to plotter, but save job in file. eCOM writes files directly to cutter port, without plotter driver (works only with COM ports). In common case eCut connect to plotter through plotter drive, but if You have COM-port connection, then You can use eCom.exe (about using eCom read in FAQ page).ĪTTENTION! If You Use Chinese cutter (nonOFFSET) there can be problems in use plotter driver (cutter can stop in wrong places or cut wrong lines). Also there are a lot of algorithms in eCUT, that makes curve look more smooth, can change first point of curve, sort curves, emulate OFFSET and etc… Because module prepares a file independently. That means, there is a necessity for importation of the information to other program! eCUT is relieved Of this lack, as a matter of fact is part CorelDraw.Ĭutting over driver in some cases leads to bad quality of curves, especially on long blocks. One of the most important inconveniences is that all these software are separate programs! Any separately taken software has both lacks and advantages. ![]() Working with cutter, many people face a problem of a choice of the software. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |